|
#870 - Sparkle Action 700 Power Supply |
|
|
|
Written by Zach Jeffers
|
|
Tuesday, 11 September 2007 |
|
Page 2 of 4
Features:
- Complied with EPS12V standard
- Active Power Factor Correction (PFC) meet EN61000-3-2
- High efficiency and reliability
- Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
- Remote ON/OFF function
- Internal 12V DC fan included
- Noise Killer (thermal fan speed control function)
- Low noise and ripple
- Output over voltage, short circuit, and over current protection
- 100% Hi-pot, ATE, and burn-in tested
- Re-settable power shut down
- Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
- Approved by UL60950, CSA C22.2 NO. 60 or VDE EN60950, NEMKO EN60950 (CB Report), CE
Specifications:
Temperature Range: Operation at 0° ~ 50°C on full load, de-rate 8W/°C from 25° ~ 50°C; storage & shipping: -20° ~ +80°C
Humidity: 5 ~ 95% on operating and storage
Dielectric Withstand: Primary to Frame Ground 1800 VAC for 1 sec.
Efficiency: up to 85%
Rise time: Less than 20ms
Hold-up Time: 17ms minimum at nominal input voltage
Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
Leakage Current: Less than 3.5mA
MTBF: 100,000 hours on maximum load at +25°C
Dimensions (LxWxH): 140x150x86mm / 5.5x5.9x3.4in
Input Range: 99 ~ 265Vac (RMS), Full Range Input
Frequency: 47 ~ 63Hz
Input Current: 8A (RMS) @115Vac, 4A (RMS) @230Vac
Inrush Current: No damage, typical 100A at cold start
Average Output Voltage:
- +3.3V @ 18A
- +5V @ 15A
- +12V1 @ 9A
- +12V2 @ 9A
- +12V3 @ 9A
- +12V4 @ 9A
- -12V @ 0.4A
- +5Vsb @ 1.5A
Packaging:
Sparkle sent the Action 700 power supply in a standard brown shipping box. Inside of the shipping container was the Action 700 retail box. This is a plastic wrapped outer container with a white cardboard box inside. With the top flipped open you can see that the unit has been well constrained and protected by foam and cardboard.
  
|
